Brakes; Testing Brake Functions - Kogan FORTIS 700C User Manual

Step 9: Brakes
A er installing the front wheel, re-connect the front brake by squeezing the arms together,
and sliding the cable guide back into the carrier (Figures 18 & 19).
WARNING: When assembling or adjusting the brakes, make sure the cable anchor
nut is tight (Figure 18). Failure to securely tighten the nut could result in brake failure
and personal injury.

Testing Brake Functions

To test the function of the front hand brake, li the front of the bike and spin the wheel. The
wheel should not rub on the brake pads. Next, squeeze the brake lever and take note of the
brake pads contacting the side of the wheel. The pads should contact the rim on both sides
at the same time. Finally, hold the brake lever firm and try to move the bike forward. The
brake should hold well enough to keep the wheel from moving. Repeat these steps for the
rear wheel.
r
Figure 18 Figure 19