Installing The Seat; Installing The Rear Seat Reflector - Kogan FORTIS 700C User Manual

Step 4: Installing the seat
• Add some white grease to the inside of the seat tube, and slide the seat post into the
bicycle.
• Make sure that the minimum insertion mark is completely covered and that the seat is
pointing forward in alignment with the bicycle (Figures 6 & 7).
WARNING: The seat post must be inserted far enough so that the minimum
insertion marks cannot be seen.
Step 5: Installing the rear seat reflector
• Remove the seat post and seat.
• Loosen the screw on the clamp of the reflector until you can slide the reflector over the
seat post.
• Once the reflector is on the seat post, reinsert the seat post back into the seat tube.
• Position the reflector so that it is perpendicular to the ground, and move it up on the
seat post until it can be seen above the tire when viewing the bike from the rear
(Figure 8).
Figure 6
Figure 8
Figure 7