Optimus EDC-1000 Series Instruction Manual page 24

3. SYSTEM SETTINGS
3.1. Start up
•
After making sure that all wiring is done, switch on the main controller and the LCD will display
following information:
•
Then, system will boot and auto-scan all connected conference microphones; LCD will display
the following information:
•
After scanning the microphones the following information will be displayed (default page):
Note:
When the main controller is turned on, the system will automatically scan all microphones.
Red LED ring on indicates that microphone is working correctly while blinking one indicates
connection failure. In this case turn off the unit and check the microphone connection. Then turn on
the unit to scan again the microphones.
To finish auto scan press any of the microphone key or wait for 30 seconds, light ring on
microphones will be turned off and the conference will be ready to go.
EDC-1000 Version 2
EDC-1000 SERIES
Conference System
Page 7 of 16