OCULUS Go Cleaning Manual

Hide thumbs Also See for Go:

Cleaning the Facial Interface (foam)

Cleaning the foam-based facial interface of the Oculus Go is vital when a single headset is being

utilised by multiple users. Thankfully, cleaning an Oculus Go headset is simple. Please note: this may

require multiple wipes.

1. Lift the plastic arms holding the strap into a vertical position.

2. Remove the Facial Interface from the Oculus Go headset. With the inside of the headset (with

the lenses) facing you, grab the left-side of the foam and pull towards the right, the foam

should simply slide out from under the lenses.

3. Wipe the Dark side of the Facial Interface with an anti-bacterial wipe. Be sure to deeply clean

the top of the Facial Interface (which makes contact with the forehead), as well as the

bottom-middle areas (which make contact with the cheek bones); these are the key areas

where cleaning is pivotal.

Cornerstone™

Table of Contents

Do you have a question about the Go and is the answer not in the manual?

Page 1 Cleaning the Facial Interface (foam) Cleaning the foam-based facial interface of the Oculus Go is vital when a single headset is being utilised by multiple users. Thankfully, cleaning an Oculus Go headset is simple. Please note: this may require multiple wipes.
Page 2 4. Lastly, make sure to deep clean the nose gap section of the Facial Interface. Washing the Facial Interface (foam) If the facial interface is too dirty to clean with anti-bacterial wipes, you can wash the headset under the tap with cold water and a small amount of detergent. If you have 10 or more Facial Interfaces to clean, you may use a washing machine for no longer than 30 minutes using cold water.
Page 4 VR HEADSET CLEANING GUIDE FOR OCULUS GO...