Charging And Discharging With The; Lego ® Power Functions Battery Box - LEGO Renewable Energy Meter Getting Started

Charging.and.discharging.with.the.LEGO

Charging and discharging with the

LEGO Power Functions Battery Box
®
Charging the Energy Meter
Step 1
Make sure that the Power Functions Battery
Box is fitted with six new batteries before
beginning. Rechargeable batteries can
be used.
Step 2
Connect the Power Functions Battery Box to
the Input plug at the back of the Energy Meter
with the Power Functions Extension Wire.
Step 3
Turn on the Power Functions Battery Box by
moving the orange slider button to the right or
left. The Battery Box is on when the green light
is on.
Step 4
Make sure the Energy Meter is on. Turn on the
Energy Meter by pressing the green On/Off
button. Charging will now begin.
Charging is complete when the display turns
off. Even though the display may show 100 J,
the Energy Meter is not fully charged until the
display turns off.
LEGO, the LEGO logo, MINDSTORMS and the MINDSTORMS logo are trademarks of/sont des marques de commerce de/son de marcas registradas
de LEGO Group. ©2010 The LEGO Group.
.Power.Functions.Battery.Box
®
INFO
Remember that charging
and discharging the
Energy Meter must
always be done under
adult supervision.
INFO
A full charge normally
takes approximately one
to three hours.
5