AerodromeRC NIEUPORT 28 Instructions Manual page 12

www.AerodromeRC.com Nieuport 28 53" 1/6th Scale Page 12
COVERING low the instructions on the plan for their construction.
Gary used Nelson LiteFab to cover the entire model but
Polypan is also is a great choice.
S�������
Cut stencils (files are available from www.aerodromerc.
com for download at no charge) and paint them with a
brush or airbrush.
ASSEMBLY
A�er the finishing, hinge all control surfaces and control
horns. The horizontal stabilizer must be a�ached to the
fuselage before hinging the elevator. You might prefer not
to glue the rudder control horns in place, so you can move
them slightly to adjust minor differences in the length of
your control cables or pushrods. Pull-pull rudder control is
recommended to keep rear weight down.
FITTING RIGGING
Use strong thread or Kevlar fishing line or elastic beading
cord to simulate rigging wires. Use small screws, fishing
hook eyes, straight pinheads or small eyelets to a�ach the
lines. These "wires" while not required, can add a degree
of strength to your model.
D���� M������ G��� ��� P���� F�����
Dummy machine guns and a pilot figure is included. Fol-
Copyright© 2008-11 M.K. Bengtson All Rights Reserved Rev 07/11