Table of Contents
Advertisement
ATTENTION!
–
Before installation, check the scope of delivery of the filter system for completeness and possible
damage. If damaged parts are included in the delivery, please inform your sales partner.
–
When installing the filter system, make sure that the screws provided for the respective position are
securely fastened (length and torque).
–
The dimensions of the screws, threaded bolts, washers and nuts as well as the tightening torque can be
found in the respective quotation drawing.
–
The inlet and outlet lines used must be approved for the filter medium used (e.g. oil or fuel). Unsuitable
pipe materials can lead to leaks in the filter system.
–
Make sure that no existing installations are damaged by the installation of the filter system.
–
When connecting the inlet and outlet nozzles, make sure that the nozzles are not deformed by too tightly
tightened fastenings (e.g. hose clamps).
–
When installing the filter system, reattach the cable and hose clips that you removed when removing the
filter system to the same place.
–
After installation and maintenance, secure cables and hoses against unintentional movement.
–
The connecting cables of the application must be able to be connected to the filter system without kinks
or abrasion.
–
Immediately eliminate any faults that may impair safety during operation of the filter system.
–
If there is visible damage to the filter system and its components, they must not be obstructed and put
into operation. Damage to the housing can impair the function of the filter system.
–
Report any changes (including operating behavior) that affect the functional safety to the manufacturer
or seller immediately.
–
Install the filter system so that vibration, temperature and humidity (e.g. splash water or rain) cannot
damage the application or the components of the filter system.
–
When working on the application, the filter system must not be misused as a climbing aid.
–
Do not use the filter system in humid environments if the housing design of the filter system is not
waterproof. Follow the instructions on the filter system or in the respective documentation.
–
If the filter system has a plastic housing, there is a risk of electrostatic discharge. Ensure a conductive
connection to the installation site when installing the filter system.
–
When installing and changing the filter system, make sure that no impurities (air, oil, fuel) enter the filter
system or the application on the clean substance side.
–
Do not operate the application without the filter system connected if this could damage the application.
–
Always operate a powered filter system only with the permissible on-board voltage. Pay attention to the
corresponding instructions on the filter system or in the respective documentation.
–
Only use service components approved by the manufacturer. Filter system components that are not
approved service components must not be replaced!
–
Operation with inadmissible components is not intended use!
–
Only use original MANN+HUMMEL replacement components.
–
Store replacement filters away from dust, moisture, damage and inaccessible to insects and rodents.
–
Dispose of the individual components of the filter system in accordance with official environmental
regulations.
–
Ensure that escaping filter media such as oil or fuel do not escape into the environment! Collect
substances that are harmful to the environment (e.g. via a collecting tray) and dispose of these
substances in accordance with official environmental regulations!
Introduction
4
Advertisement
Table of Contents
