Woods Alitec A Series Operator's Manual page 9

Skid steer cold planer
Hide thumbs Also See for Alitec A Series:
Table of Contents

Advertisement

SAFETY & INSTRUCTIONAL DECALS
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
54519
WARNING
FALLING OFF CAN RESULT IN BEING RUN OVER.
Skid steer must have ROPS and seat belt/operator restraint.
Keep seat belt/operator restraint securely fastened.
Allow no riders.
RAISED EQUIPMENT CAN DROP AND CRUSH.
Never go underneath raised equipment or raised Skid Steer lift
arms, which can drop from hydraulic leak down, hydraulic
system failures, movement of control levers or mechanical
linkage failures.
Service work does not require going underneath equipment.
Read manual instructions.
FALLING OFF OR GOING UNDERNEATH EQUIPMENT
CAN RESULT IN SERIOUS INJURY OR DEATH.
D0445
See Parts section for decal location.
MCPSSAMH (Rev. 8/25/2006)
Replace Immediately If Damaged!
54519--A
D0438
CAUTION
CRUSHING HAZARD
Do not raise or roll back the lift
arms when the valve arm is
lowered into the cab.
FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY.
BE CAREFUL!
Use a clean, damp cloth to clean safety
decals.
Avoid spraying too close to decals when
using a pressure washer; high-pressure
water can enter through very small
scratches or under edges of decals
causing them to peel or come off.
Replacement safety decals can be
ordered free from your Woods dealer. To
locate your nearest dealer, check the
Dealer Locator at
www.WoodsEquipment.com, or in the
United States and Canada call
1-800-319-6637.
D0438
Safety 9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents