Woods Alitec A Series Operator's Manual page 15

Figure 7.
2. Remove 1/4" cross bolt as shown in Figure 8.
Figure 8.
3. Remove four 3/8" motor bolts.
4. Remove the motor.
BEARING REMOVAL
1. Perform steps one through four of Motor Removal.
2. Loosen the bearing set of screws.
MCPSSAMH (Rev. 8/25/2006)
Figure 9
3. Slide shaft towards the motor side of the attach
frame until the bearing side coupler clears the
bearing.
4. Remove two 1/2" bolts.
ACME SCREW REPLACEMENT
1. Perform steps one through four of Motor Removal
and steps two though four of Bearing Removal.
2. Remove 1/4" bolts as shown in Figure 10.
Figure 10.
3. Slide couplers off the acme screw.
4. Manually turn the acme screw to back it out of the
bearing side of the sideshift frame.
Service 15