Table of Contents
Advertisement
3. INSTALLING THE BATTERIES
Open the cover on the remote control and insert 2x AAA batteries into the compartment.
The correct position of batteries polar diagram is shown inside the batteries compartment.
1. Open the cover.
2. Insert the batteries.
3. Close the lid.
WARNING:
4. USING THE REMOTE CONTROL AND USB ADAPTER
Please first insert the USB adapter of the remote control in a free USB port. This USB adapter receives
the RF (radio controlled) signals from remote control. Without this adapter only the Standby button
will work via the IR sensor (infrared). The remote control has an in-built "G-sensor" which is used as
pointer on your screen in the Android mode. This is called as "Air mouse" function and allows you to
move the pointer by moving the remote control through the air.
NOTE:
Under normal conditions your remote control has been paired with the USB adapter in the factory
and therefore the "Air mouse" function of your remote control will directly work for your receiver.
In case you can only use the
a function, or in case the red LED on the remote control keeps blinking, it could be that the pairing
between the remote control and the USB adapter is not correct.
In that case you need to pair the USB adapter to the remote control manually:
1. Remove the USB adapter from the USB slot on the receiver.
2. Make sure the receiver is switched ON.
3. Remove the batteries from the remote control and insert them again. The LED on the remote
control starts flashing.
4. Press and hold the OK and
remote control flashes more quickly.
5. Insert the USB adapter into a free USB port of the receiver and wait until the LED on the remote
control stops flashing (fig. 6).
6. Now the remote control is paired with the USB adapter.
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
As this function uses more power as normal pressing of buttons we
recommend using Alkaline batteries to ensure longer operation time
of your remote control. When the batteries are almost empty the LED
indication on the remote control will start blinking for 15 seconds after you
press any button.
button on the remote control and none of the other buttons have
buttons at the same time for a few seconds. The LED on the
Fig. 2
Fig.3
3
Advertisement
Table of Contents
