Advertisement
E T C S e t u p G u i d e
H a r d w a r e S e t u p
Connect Cables
Hard Power Switch
100-240VAC
50/60 Hz
2A@120VAC
eSATA
Port
IEC Receptacle
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
N o t e :
C on go L ig ht Se r ver S et up G u id e
USB
Ports
Ethernet Ports 1 & 2
Display
Port
USB
Ports
Attach the appropriate IEC power cord to the power connector, then to the IEC receptacle.
Connect any monitors to the proper ports on the back of the Light Server.
Congo Light Server supports up to 2 monitors using the
following combinations:
Signal
Type
Display Port
Physical
Port
Yes
Display Port
Yes
with Adapter
DVI-I Port
No
DVI-D Port
No
Multitouch monitors need to be Windows 7 or 8 Compatible.
Connect the USB mouse and keyboard to the USB connectors.
Attach a network ethernet cable to the ethernet port.
Connect optional cables as desired including remote trigger, midi, DMX, and phone
remote.
When all connections are made, switch the hard power switch on.
Press the soft power switch, on the front of the unit, to power up the Light Server.
If the unit does not power up, check the rear panel to insure the hard power switch
is on.
Audio Out
(Audio In
Reserved for
Future
Implementation)
DVI-I
DVI-D
Ports
Port
Port
DVI
VGA
Yes
with Active
Adapter
Yes
Yes
with Adapter
Yes
No
Page 2 of 3
Congo Light Server
DMX
x2
PUSH
PUSH
DMX
DMX
1
2
Remote Trigger
ETC 2U Processor Unit
C
US
Electronic Theatre Controls, Inc.
Middleton, WI
3060167
Remote
Trigger
USB
El ect r on ic T he at r e C on tr o ls , I nc.
Phone
Remote
MIDI In
Phone Remote
MIDI Out
USA
Midi In
& Out
Advertisement
