URBANGLIDE RIDE 100 PRO Translation Of The Original Instructions page 10

Fault display
Battery level
Instructions of Buttons
1- Switch: long press the power button to turn on/off the power;
2- Acceleration: press the right acceleration button to start and accelerate;
3- Brake: hold the brake handle to brake.Lightly step on the rear fender to assist the
brakes
4- Short press the function key to directly adjust the speed
•
• Beginner mode: no characters in the gear position
• Normal mode: gear characters display white
• Sports mode: gear characters display red
•
5- Headlights: Press the function button twice shortly to turn on the headlights, and the
taillights are
always on; In the light-on state, press the function button twice shortly to turn off the
headlights and taillights
6- Cruise mode: keep the current speed for 6 seconds to enter the cruise mode
7- Exit the cruise mode when pressing accelerator again or brake
Pre-assembly instructions
1. Pull up the lever while
pressing down the rear wheel
fender.
2. Raise the pole, fasten the
folding spanner, and use the
folder fixing ring to fix the
folder wrench.
7
Speed
Function
Speed level
Unit display
3. Fix the brake lever with
M5 hex wrench.
EN