Door Reverse - Nevir NVR-4402 NSD Owner's Manual

DOOR REVERSE

This fridge has been built with the door hinges on the right. If you want to change the opening
direction, please follow the instruction below:
1. Remove the four screws (1) (2) and take away the top.
2. Remove the two screws (3) that hold the upper hinge (4) and take away the upper hinge (4).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the three screws (5) that hold the lower hinge (6) and make sure to remove the lower
hinge(6).
5. Remove the adjustable leg (8) and transfer it to right side.
6. Remove the bolt-pin (7) and reverse the direction of lower hinge (6). Install the lower hinge (6)
into left side with three screws (7).
7. Insert the bolt-pin (7) to the lower hinge (5).
8. Remove the hinge pin (9) that is in the bottom of door. At the other side of door, insert the
replacement hinge pin that is supplied with the appliance.
9. Set the door to its place and make sure the door seat at the lower hinge (6).
10. Fix the upper hinge (4) with the two screws (3) and the top with four screws (1) (2).
gure 1
Figure 1: Represents position of components prior to door reversal
Figure 2: Represents position of components after door reversal
2
1
4
3
8
7
6
5
9
2
4
3
7
6
5
-16-
1
8
9
gure 2