glass 1989 NOOR STEAM MODULE Installation, Operation & Maintenance Manual page 10

Hide thumbs Also See for NOOR STEAM MODULE:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 9
EN
Do not remove the sticker from the product!
Figure A
product.
However the instructions remain unchanged.
considered suitable without notice or replacement.
manufacturer's name) are contained in the silver data plate
of testing.
clean, to avoid slips or falls entering or editing the product
itself.
when using soaps, shampoos, clearing detergents, etc..
too hot. Use water with a maximum temperature of 38°C.
medical check-ups to ensure being in a good health status
and who have pacemakers.
people or pregnant women should consult a doctor before
using the product.
affect heart beat, blood pressure and circulation.
unconsciousness.
given appropriate supervision or instruction concerning use
of misuse.
turning off the double-pole switch installed on upstream the
appliance.
All measurements are in mm.
PRE-INSTALLATION REQUIREMENTS
120 kPa (1,2 bar)
350 kPa (max 3,5 bar)
max 60°C
installation requirements) is supplied in all versions except the
manual version.
When making the connection to the electrical mains, a double-
the relevant standards.
EQUIPOTENTIAL CONNECTION.
The equipment must be connected to the equipotential
found in the product.
The
following
accessories
waterworks:
ROUTINE AND
SPECIAL MAINTENANCE
Use water up to a maximum of 60°C to maintain the shine of the
Use soft cloths and neutral non- abrasive liquid detergents
sponges, metal pads, solid and liquid detergents containing
abrasive substances, alcohol, acids for domestic use, acetone
or other solvents that can damage the surface.
In case of lime deposit it is advised to usea lemon juice.
personnel.
In case of failures or malfunctioning of the product, contact
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
All electrical connection checkup must be performed by an
electrical installation technician.
If there is no response from the wall controls, check that:
- The switch is on.
- The appliance is powered. Check that the domestic power
10
C.P. (see Pre-
(not
supplied
by
the

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents