Advertisement
Step 1
Remove transportation blocks
from the bottom of each panel
before beginning assembly.
Each Panel should have two
blocks.
Step 2
Assembly
Place floor on a firm and
level base, ensure base has
suitable drainage free from
areas where standing water
can collect. (see front page
on base requirements).
Step 3
Fix the corners with 3x
50mm screw a shown in
diagram.
Do not secure the building
to the floor until the roof is
fitted. Fix the panels onto
the floor using 50mm
screws in alignment with
the floor joists
Position the panels so there is
equal spacing between the
floor and cladding on all 4 sides
Step 4
Fix door gable and front panel
using same method shown in
step 3.
Step 5
*Shiplap Only
Place the Gable Top onto the
plain gable, ensuring the
cladding and framing on either
side is flush with gable. Fix with
2x30mm screws as shown in
diagram.
9 x 50mm screws
15 x 50mm screws
4 x 30mm screws
*Shiplap Only
Advertisement
