Installation - NDS Plus 25 User Manual

8. installation

powerservice
the external flanges (aluminum feet).
The ideal mounting position is smooth, well ventilated and not
subject to overheating; avoid surfaces covered with fabric or
carpet. Install the device as close as possible to the service
batteries.
powerservice
vertical wall, it is recommended to keep the short side parallel
to the floor, with connections downwards. Do not install the
device close to sources of heat or in a place that is not
adequately ventilated and that could reach very high
temperatures (eg. engine compartment).
caution
powerservice
charger, therefore: pre-existing chargers, external chargers,
integrated in the control unit chargers, must be uninstalled!
1. Set the power switch to 0.
2. Connect the negative pole of the STARTer BATTERY to
powerservice
can be installed easily and securely thanks to
can work in any position; if installed on a
Gold version integrates a 230VAC battery
Pin N°1.
16