Basic Dimensions; Piping Layout - American Standard Aerozen G2 Installation Manual

Basic Dimensions

Dimensional drawings are available for each model.
Finished
wall
15 5
L=305
1

Piping layout

Dimension unit: mm
Finished ground
Water supply angle valve:
The connection dimension of water supply angle valve is 1/2 inch
of straight thread.
Blow-down pipe:
When installing a standard pipe with an inner diameter of
102mm, make sure that the horizontal blow-down pipe must be
installed at a certain gradient (2mm per 100mm).
- 3 -
New effective length
of the power supply: 1.0m
Note:
This dimensional drawing is for reference
only and the specific dimensions of the
product may vary within tolerances.
Unit: mm
Finished ground