AMX VST Instruction Manual page 12

ViewStat Programming Protocol
Programming Quick Reference (Cont.)
Command
HIBP
LOBP
DATE
TIME
PMES1
PMES2
PMES3
PMES4
TMPMES
MENU
MSG
FANLK
MODELK
NETLK
UPDNLK
LKTIME
LKLIMIT
CC
CO
Ln
(n = 1 to 4)
(Cont.)
8
Description
Thermostat HVAC Operational Commands (Cont.)
Temperature value above which W1 terminal
is locked out (heat pump equipment configura-
tion only).
Temperature value below which compressor
terminals are locked out (heat pump equip-
ment configuration only).
Text Messaging Commands
Thermostat date value
Thermostat time value
1st message in the permanent message
sequence
2nd message in the permanent message
sequence
3rd message in the permanent message
sequence
4th message in the permanent message
sequence
Temporary message
Operates the text messaging display in a User-
Interactive mode. MSG is used to display mes-
sages when MENU is on.
User-Interactive message
Keypad Lockout Commands
Determines the degree to which the user is
locked out of fan control.
Determines the degree to which the user is
locked out of mode control.
Determines the degree to which the user is
locked out of network override control.
Determines the degree to which the user is
locked out of increment/decrement control.
Time value (minutes) that an input change is
allowed until it reverts back to the pre-change
value.
Number limit that the increment/decrement is
allowed to change when locked.
Monitoring Module Commands
Digital Input States
Digital Output States
Comm. Card LED Light 1,2,3 or 4
ViewStat Communicating Thermostat - Programming Protocol Reference Guide
Value
40° - 80°, 5° increments
0° - 40°, 5° increments
MMDDYY
HHMM
32 character text string
32 character text string
32 character text string
32 character text string
32 character text string
ON/OFF
32 character text string
0=no lockout,
1=time limited change,
2=total lockout
0=no lockout,
1=time limited change,
2=total lockout
0=no lockout,
1=total lockout
0=no lockout,
1=time limited change,
2=time and value limited change,
3=total lockout
Integer value between 0 and 255
Integer value between 0 and 20
All of these commands will simply return a
response - no action at the thermostat
occurs. If inquired all will respond as
though all inputs/outputs/led's are OFF.