Symbols And Definitions Used - Stiga ZT 5132 T Workshop Manual

WORKSHOP MANUAL

1.1.3 Symbols and Definitions used

a) Symbols
They are used to draw the attention of the operator, reminding him to perform the interventions
with the necessary attention and caution.
Indicates operations that should be carried out with utmost care to avoid impairing the func-
tionality and safety of the machine.
Indicates operations that should be carried out with utmost care to avoid injury to operators.
Highlights all those operations that require different working methods depending on the type
of machine, subsequent modifications and the accessories fitted.
Indicates cross-reference to other parts of the manual, followed by the number of the relevant
chapter, paragraph or sub-paragraph.
b) Safety terminology and notes
Some paragraphs are preceded by a definition that highlights their importance:
NOTE General reference for the correct maintenance execution and methods.
IMPORTANT Specific procedures or information necessary to avoid damage to the machine or
equipment.
WARNING! Non-observance will result in the risk of injury to oneself or others.
DANGER! Non-observance will result in the risk of serious injury or death to oneself or
others.
c) Spatial References
Whenever reference is made to a position on the machine "front",
"back", "left" or "right" side, this refers to the positions of the seat-
ed operator.
d) Abbreviations and glossary
The following abbreviations are used in this manual
Rh / Lh
Min / Max
Chap.
Par.
HST
PTO
ZT 5132 T
= Right / Left
= Minimum / Maximum
= Chapter
= Paragraph
= Hydrostatic Transmission
= Power takeoff
Chapter
1 - INTRODUCTION
EDITION PAGE
2017 4 /
58