Priming The Unit - Swann Retro SK22150 Manual

CAUTION: PRESSURE
In order to avoid possible burns to body parts and/or other injury from hot steam
and water or damage to the unit, never remove the water reservoir or the porta-
filter while your espresso/cappuccino maker is brewing coffee or frothing.
Make sure the three lights are on before you remove the porta-filter to make addi-
tional cups of coffee. If you need to add more water or milk to the reservoirs, please
make sure the three lights are on and ensure to switch off the unit by pressing the
button on the side of the unit to the off position "O".

PRIMING THE UNIT

To prime unit, run the steam cycle for 90 seconds by following the steps below:
1. Fill water tank between the "Min" and "Max" levels.
2. Fill the milk tank with water between the "Min" and "Max" levels.
3. Select one of the filters and place it in the porta-filter. Place the porta-filter in
the unit ensuring it is properly locked and place a cup under it. Also, make sure
the tip of the frothed milk dispensing tube is inside the cup.
4. Plug the appliance into the appropriate outlet.
5. Turn the switch on "I" (located at right hand side of the unit).
6. The six control panel lights will start blinking. Once these lights become solid,
press the cappuccino button twice.
7. Once this process is completed, the six control panels will turn on solid.
Now your unit has been primed and is ready to be used.
SELECTING THE RIGHT CUP
Before preparing your beverage, please make sure to select the right cup size ac-
cording to the following table:
SK22150_IM.indd 10
BEVERAGE TYPE RATIO
ESPRESSO Single
Double
CAPPUCCINO Single
Double
LATTE Single
Double
HOW TO USE
60ml
119ml
178ml
355ml
296ml
474ml
10
06/08/2020 09:21