How To Charge - Cycle Torch Bolt Combo User Manual

3

How to Charge

FRONT BOLT & TAIL BOLT
1
Remove the rubber cap at the
bottom of Front Bolt / Tail Bolt;
TIPS AND TRICKS:
• When your PC is in sleep state, the light cannot be charged;
• Flashing light of the power button shows that a charging error has occurred. Remove and reinsert
the USB cable, then begin the recharge process again;
• The battery charges to about 80% after approximately 2 hours;
• Charging and lighting times are approximate values and will vary by environmental and user conditions.
The cable (or other accessories) supplied with the Cycle Torch bike lights MUST be
used only to charge the Cycle Torch bike lights. The Manufacture or/and the Seller
are not responsible for any damage caused by using the supplied accessories with
devices other than Cycle Torch bike lights.
WARNING
WARNING
FRONT & TAIL BOLTS USER MANUAL
2
Connect the Front Bolt / Tail
Bolt to your PC or a 5V max 2A
USB battery charger with the
USB cable. The lens lights up
red when the charging starts;
3
When the lens lights up green
- charging is complete. Remove
the USB cable;
Full charging time: 2 ~ 4 hours
5