ohmex KTL 1702 DG Instruction Manual page 56

EN
TEMPERATURE MAINTENANCE
• Place the kettle (1) filled with water (max 1,7 L - min 0,5 L) on the stand (4); the appliance
emits two beeps and the led indicator (11a) lights up green.
• Press and hold the power button (11) for about 2 seconds, the appliance emits a beep
and the LED indicator (11a) lights up red.
The appliance starts itself at the default temperature of
• The desired temperature can be set by turning the button (11).
The display flashes three times and shows the set temperature
40°C > 50°C > 60°C > 70°C > 80°C > 90°C > 100°C
If the water temperature is lower than the set temperature (by about
5°C), the appliance heats the water until the temperature is reached.
The water temperature is maintained for 2 hours.
If the appliance is lifted from the base, the temperature maintenance
mode does not work.
• To turn off the appliance:
- lift the kettle (1) from the stand (4), or
- disconnect the plug from the power socket.
- Do not open the cover to pour hot or boiling water from the kettle (1).
- When water boils, steam leaks out from the nozzle (5) ; pay attention.
- To move the kettle or to pour water, firmly hold the kettle (1) by the
handle (2) and work carefully.
Burns danger !!
- When the kettle is hot, do not insert your hands in the glass and do not
touch its base.
Burns danger!
52
USE
KTL 1702 DG
100°C.