ohmex KTL 1702 DG Instruction Manual page 54

EN
• At the appliance first use rinse the kettle (1) then let clean water boil three or four times
consecutively without adding any additive.
Empty the kettle (1) and make sure that it is clean.
☞
Do not fill the kettle (1) with water beyond the maximum level
(1700ml)which can be seen through the appropriate indicator (8).
• Press the button (7) and open the cover (3).
• Fill the kettle with cold water (1) as you desire.
☞
Perform this operation away from the power stand (4).
For a correct functioning, make sure that the water quantity in the kettle
(1) is never lower than the minimum level (500ml) or higher than the
maximum one (1700ml).
If the kettle (1) is excessively filled, a boiling water leakage could
occur, with subsequent burns danger !!
• Close the cover (3) by pressing it downward until you hear it coupling.
☞
A wrong cover (3) closing could cause overflows, steam leakages
and an automatic shut down switch irregular functioning.
• Place the kettle (1) on the power stand (4), making sure that both are perfectly levelled.
50
AT FIRST USE
USE
KTL 1702 DG