Gastro-M C-800 Manual page 20

If you intent to use your icemaker periodically, through seasons,
it is better to follow procedure of cleaning the device, plus stop power
supply and blow air in pump circuit, in order to remove all water from
pump circuit
In case you need to transport your icemaker it's better to place
it's at its feet. If thaw cannot be followed and the icemaker is placed in
some else way, then after transportation leave in for 2 hours in its feet
before using it.
If you decide to scrap your icemaker, please proceed as follows:
1. First disconnect power cord and cut wire from the point it comes out of
the icemaker.
2. Dispose all materials to each kind.
3. Make sure refrigerant coolant coolant and oil from compressor, are not
escaping to environment.
4. Make sure all above, proceeded in compliance with your country
regulations.
Electrical safety against shock, is clearly bind with the
appropriate connection icemakers power cord to an efficient earthing
system. Be sure before installation there is an efficiemt earth system.
After installation destroy any plastic bag, that could cause suffocation to
a child.
Do not leave a child to reach the icemaker with the intent to play with
it.
-During winter, ambient temperature 18 degrees around the frond of the
machine: Position cold plate thermostat (Ice Size) to 4 and more
increasing gradually by half before cycle start.
-During summer, ambient temperature 34 degrees around the frond of
the machine: Position cold plate thermostat(Ice Size) to 3 and below de-
creasing gradually by half before cycle start.
The icemaker Does not work
.
TROUBLE SHOOTINGS
TIPS
Check the plug.
Check fuses for short circuit.
Check if storage is full of ice.
If so remove ice .
18