Aligning Transmitter With Ecu - Gaspar Xicoy X45Helicopter User Manual

Aligning transmitter with ECU

As the display does not photograph well we have reproduced the display readings as a green box. Turn
on the transmitter and receiver. The opening screen should show as below. Follow the steps shown to
set your radio:
Press
Transmitter
−
Adjust
Press
Stick Down
+
Trim Down
The correct adjustment of the throttle adjustment on the ECU can be verified in the second screen of the
display as used before. The percentage of the throttle position should read 0% at the position of engine
stop (trim and stick down), 100% with stick/trim full up and between 10% and 30% at idle.
Note the setting seen in the "Thrust Curve" above, could be Half Expo, Full Expo or Linear. Will change
depending on what has been set up.
This now completes radio setup and only needs doing again if the radio settings are changed.
Trim Low T=20C
RPM 00000 PW 000
Press
Enter
(Stop)
Press
Thrust curve:
+
FULL EXPO
Press Press
▲ ▲
Stick Up
+
(Full Power)
Press
Page 43
Info
Start Radio
Trim Up
Stick Down
+
Trim Up
Run
(Idle)
