Briggs & Stratton 01897-0 Installation And Owner's Manual page 4

WARNING
Running engines produce heat.Temperature of
muffler and nearby areas can reach or exceed
150°F (65°C).
Severe burns can occur on contact.
• DO NOT touch hot surfaces.
• Allow equipment to cool before touching.
WARNING
Propane and Natural Gas are extremely
flammable and explosive.
Fire or explosion can cause severe burns or
death.
• Install the fuel supply system according to applicable fuel-gas
codes.
• Before placing the Standby Generator into service, the fuel
system lines must be properly purged and leak tested.
• After the generator is installed, you should inspect the fuel
system periodically.
• NO leakage is permitted.
• DO NOT operate engine if smell of fuel is present or other
explosive conditions exist.
• DO NOT smoke around the generator.Wipe up any oil spills
immediately. Ensure that no combustible materials are left in
the generator compartment. Keep the area near the generator
clean and free of debris.
CAUTION
Excessively high operating speeds increase risk
of injury and damage to generator.
Excessively low speeds impose a heavy load.
• DO NOT tamper with governed speed. Generator supplies
correct rated frequency and voltage when running at governed
speed.
• DO NOT modify generator in any way.
Briggs & Stratton Power Products Standby Generator
Installation, Start-Up and Owner's Manual
• See "Essential Circuits" on page 9.
• Start generator and let engine stabilize before connecting
• Use generator only for intended uses.
• If you have questions about intended use, ask dealer or
• Operate generator only on level surfaces.
• Adequate, unobstructed flow of cooling and ventilating air is
• The access door and roof must be installed whenever the unit
• DO NOT expose generator to excessive moisture, dust, dirt,
• Despite the safe design of the Standby Generator, operating this
• Remain alert at all times while working on this equipment.
• DO NOT start engine with air cleaner or air cleaner cover
• DO NOT insert any objects through cooling slots.
• DO NOT use the generator or any of its parts as a step.
• If connected devices overheat, turn them off and disconnect
• Shut off generator if:
4
CAUTION
Exceeding generators wattage/amperage capacity can
damage generator and/or electrical devices connected
to it.
electrical loads.
CAUTION
Improper treatment of generator can damage it and
shorten its life.
contact Briggs and Stratton.
critical to correct generator operation.
is running.
or corrosive vapors.
equipment imprudently, neglecting its maintenance or being
careless can cause possible injury or death.
Never work on the equipment when you are physically or
mentally fatigued.
removed.
Stepping on the unit can cause stress and break parts.This
may result in dangerous operating conditions from leaking
exhaust gases, fuel leakage, oil leakage, ect..
them from generator.
-electrical output is lost;
-equipment sparks, smokes, or emits flames;
-unit vibrates excessively.