Caution For Ac Mains Lead; Before Use; How To Replace The Fuse - Panasonic HC-PV100GC Service Manual

DO NOT REMOVE THE OUTER COVER
To prevent electric shock, do not remove the cover. No user serviceable parts inside. Refer servicing to qualifed service personnel.

2.2.2 Caution for AC Mains Lead

For your safety, please read the following text carefully.
This appliance is supplied with a moulded three-pin mains plug for your safety and convenience.
A 5-ampere fuse is ftted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5 amperes and it is approved by ASTA or BSI to
BS1362
Check for the ASTA mark or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover you must ensure that it is reftted when the fuse is replaced.
If you lose the fuse cover, the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
If the ftted moulded plug is unsuitable for the socket outlet in your home then the fuse should be removed and the plug cut off and disposed of
safety.
There is a danger of severe electrical shock if the cut off plug is inserted into any 13-ampere socket.
If a new plug is to be ftted please observe the wiring code as shown below.
If in any doubt, please consult a qualifed electrician.
2.2.2.1 Important
The wires in this mains lead are coloured in accordance with the following code:
Blue Neutral
Brown Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED.
Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the
Earth Symbol.

2.2.2.2 Before Use

Remove the Connector Cover as follows.

2.2.2.3 How to Replace the Fuse

1. Remove the Fuse Cover with a screwdriver.
file:///C|/U...al/Temp/Rar$EXa0.559/viewing/SGML_VIEW_DATA/ALL/HC-PV100GC/SVC/VM1609006CE/doc/VM1609006CE_02.xml[11/12/2018 2:36:14 PM]