Advertisement
AAPRODUCTS INC.
S
TEP 3
Remove the two factory bolts(Fig1), (if equipped), along the side panel find the SECOND SET of the threaded holes to mount
the center Bracket, and the very last two factory bolts, (if equipped), along the side panel to mount the rear Bracket. Partially
attach center and rear Brackets to the vehicle with Hex Head Bolt M8, Spring Washers M8 and Washers M8(Fig2).
FIG1
Remove two
factory bolts
S
TEP 4
Now install Step Rail on the brackets. Place the Step Rail on the installed mounting brackets.
Align the holes of Step Rail with the holes on the brackets and drop them into place. Next thread the provided Hex Head Bolt
( M10 ) & washer ( M10) & Spring washer (M10) to hold the Step Rail and leave loose. Adjust the Step Rail in place to your
liking, tighten all fasteners on the brackets. Front and rear first and then the center brackets finally the Step Rail.
Repeat procedure for other side.
Complete your installation. Enjoy!
For Technical Support Call:1-888-806- 3972 / 626-332-4245
FIG2
Hex Hea Bolt(M8)
&
Washer(M8)
BRACKET
Hex Hea Bolt(M10)
&
Spring Washer(M10)
&
Washer(M10)
I
NSTRUCTION MANUAL
BRACKET FACING
REAR OF VEHICLE
&
Spring Washer(M8)
Advertisement
