Adjustment Of The Air-Termination Rod In Case Of Roof Inclinations Up To; An Inclination Angle Of 10; Adjustment Of The Adapter - dehn 105 525 Installation Instructions Manual

3.3

Adjustment of the air-termination rod in case of roof inclinations up to

an inclination angle of 10°

3.3.1 Adjustment of the adapter

Isolated air-termination rods with a diameter of 22 mm can be inserted into the adapter attached to
brace frame. This adapter compensates air-termination rods in case of roof inclinations or slopes up to
an inclination angle of 10° (see Figure 8).
Depending on the inclination angle, the tubular air-termination rod (Ø 22/16/10 mm; StSt) is inserted
into the adapter and the four M8 locking bolts are tightened.
Moreover, the four hexagon nuts have to tightened against the adapter. The specified tightening tor-
ques have to be observed (see Figure 7 on page 12 and Figure 8).
M8 hexagon nut
Figure 8 Adjustment of the adapter on the brace frame
max. 10° tubular air-termination rod /
air-termination rod
Ø 22 / 16 / 10 (Al, AI / StSt)
length of 2500 / 3000 / 3500
M8 locking screw
tightening torque of 15 Nm
13