Zenner MinoConnect Installation Manual page 5

Reset Bluetooth-Pairing
■
In the ON-state please press the button (about 10 sec.)
till the blue LED is flashing, then release the button.
■
As soon as the blue LED is lighting the pairing is erased.
■
The LED lights for about 3 seconds. After this time the
MinoConnect switches off and must be turned on.
The MinoConnect is now visible to other Bluetooth devices
again and can be reconnected.
Connection via Bluetooth
With factory settings, MinoConnect is visible to other Blue-
tooth devices and waits for connection attempts. MinoCon-
nect is being recognized by other devices with the name
"MiCon_xxxx" where xxxx corresponds to the last four di-
gits of the Bluetooth serial number. The Bluetooth serial
number is printed on each MinoConnect. Once the desi-
red MinoConnect is found, it can be connected. The PIN /
password to be entered to the connecting device is „0000".
Note: If a MinoConnect has been paired with another Blue-
tooth-device, he is no longer visible for other Bluetooth-de-
vices. Only after a „Bluetooth Pairing Reset" the MinoCon-
nect becomes visible again and can be paired once more.
Device recognition
Similar as to any other serial interface, a variety of devices
can be connected to MinoConnect. Depending on which
device is connected, different protocols must be used, and
different supply voltages or drivers have to be applied.
MinoConnect basically does not offer any automatic recog-
nition and setting about the supplies or interfaces.
But MinoConnect can provide information about the device
which is connected, if the device has a corresponding re-
sistance in the D-Sub connector between pin 1 and pin 5
and if the software GMM is being used. A special status
in the device recognition represents the highest level (or
7V_AUTO_ON 680kOhm). Once this resistance is reliab-
ly detected, MinoConnect independently switches the 7V
supply to the output.
This function allows the internal power source to be used
directly. Main use of this feature is the easy setup and trou-
bleshooting ZR-Bus networks.
ZENNER International GmbH & Co. KG
Römerstadt 6
D - 66121 Saarbrücken
Telephone +49 681 99 676-30
Telefax +49 681 99 676-3100
Disposal
This device contains non removable and non-rechargeable
batteries (must be verified depending on the product).
Batteries contain substances, which could harm the envi-
ronment and might endanger human health if not disposed
of properly.
To reduce the disposal quantity so as unavoidable pollu-
tants from electrical and electronic equipment in waste, old
equipment should be reused prior or materials recycled or
reused as an other form.
This is only possible if old equipment, which contains bat-
teries or other accessories are disposed. Therefore please
contact the department of your local authority which is res-
ponsible for waste disposal. Alternatively a waste disposal
via ZENNER is possible.
Your local or municipal authority or the local waste disposal
company can give you information relating the collection
points for your used equipments.
Attention
Do not dispose of the devices with domestic waste.
In this way, you will help to protect natural resources and to
promote the sustainable reuse of material resources.
For any question, please contact
The most up-to-date information about this product and of
our installation notice can be found at
E-Mail info@zenner.com
Internet www.zenner.com
info@zenner.com
www.zenner.com.
5