Tips On Measurement - Parkside 315836 1904 Operation And Safety Notes

the AC search, the detector can be guided in
all the four directions (Fig. B).
  
I ntegrated Pencil:
A pencil
the delivery content. Included pencil
be stored inside the product by inserting the
pencil
4
on the right side of the product. Make sure to
insert the pencil
pencil hole on the product. When necessary,
the pencil
cil hole.
 
I f one (or) a few more bars appear on the
display whilst slow scanning repeatedly at a
particular location of a wall, there could be
an object, for which the search is activated
present in that part of the wall. Due to an air-
gap inside the wall (or) other similar issue
not, not all full bars are observed and no
beep sounds. In this case, scan by moving
fast one (or) more time(s). All full bars will be
observed and beep sounds during fast move-
ment scanning at that particular location to
confirm the presence of the searched object.

Tips on measurement


 
T he PUSH button
during the entire search process (calibration
and search).
 
I f you calibrate too closely to the object or di-
rectly on the object, the calibration can fail. If
the calibration fails, the LC display shows the
full intensity (Fig. C) and a long beeping tone
sounds or can't search any object in the wall.
Move and hold the product several centimeters
has been included together with
4
on the pencil hole, which is located
into the intended slot of the
4
can be taken out from the pen-
4
must remain pressed
5
can
4
GB/IE 29