Basalte ASANO BO.sensor 770-01 Installation Manual

ASANO BO.sensor
Installation Manual
Safety instructions
Before operating the unit, please read this manual thoroughly and retain it
for future reference.
Failure to observe these instructions might damage the device
The device may only be installed and connected by professional electricians
Description
BO.sensor integrates Bang & Olufsen infrared remote controls with
KNX systems and allows controlling KNX lights, screens and
scenes with the Beo 4 and Beo 6 remotes.
BO.sensor supports all AV controls like TV, RADIO and DVD,
allowing you to control the complete Asano system.
The BO.sensor module sits behind the original Bang & Olufsen
infrared sensor powering it directly from the KNX bus without any
additional power supply
(Bang & Olufsen infrared sensor not included)
Components
Model No. 770-01
A KNX connector
B Programming button
C Programming led
D Beolink connector
E Connector pins
IMPORTANT ADVICE

Never connect the device to 230V or in the vicinity of. Make sure to maintain the distance to them specified in
the applicable standards and regulations.
Compatible devices
The BO.sensor is compatible with the following Bang & Olufsen infrared sensors:
Ref. n° 8089110 IR kit

These sensors can be installed in two types of wall boxes:
3375187 (solid walls)

 3375188 (dry walls)
A
.
B
C
D
E