Disconnecting The Connector; Connecting The Connector; Connector Circuit Inspection Requirements - Isuzu 2008 N Series Workshop Manual

Disconnecting the connector

Many connectors have a lock to ensure secure
connections.
The two types of locks generally used are those that
open by lifting the release area of the lock (1), and
those that open by pressing the release area (2).
Before disconnecting the connector, determine in
advance which type of lock the connector is using.
1
When disconnecting the connector, first securely grasp
the male side and female side of the connector.
Release the lock, and carefully disconnect the
connector.
Do not pull the harness when disconnecting the
connector, as this may cause wires to come out or
break.
OK
2
HCW90ASH000201
NO
LNW20ASH001301
General Information

Connecting the connector

Securely grasp the female side and male side of the
connector, and align them correctly.
Firmly push them together until both sides click into
place.
OK

Connector circuit inspection requirements

Check the continuity of the connector using a circuit
tester. Insert the probes (1) of the tester from the
harness side of the connector, as indicated in the
diagram.
1
0A-19
NO
LNW20ASH001401
OK
LNW20ASH001501