Manor P1-35837901 Instruction Manual page 5

P1-35837901
PARTS DESCRIPTION
1. Clamping ring
2. Front guard
3. Blade fastening screw
4. Fan blade
5. Guard fastening screw
6. Rear guard
7. Motor shaft
8. Oscillation button
9. Speed switch
10. Fastening screw
11. Height adjustment pipe
12. Fasten set
13. Standing shaft
14. Cover piece
15. Standing base
ASSEMBLING INSTRUCTIONS
** Please assemble correctly by the following orders when using.
1. Assemble the stand
Connect the two parts of the base together into a cross.

Unscrew the four screws from the base.

Attach the standing shaft onto the base and fix firmly with the four screws.

Rotate the fasten set out of the standing shaft. Put the cover piece on the base through the standing shaft.

Rotate back the fasten set.

2. The whole assembly
Pull the height adjustment pipe out and tighten the fasten set.

Link the fan main body and the height adjustment pipe together by the fastening screw and then fix them.

3. Rear grille assembly
Unscrew the blade fastening screw and the guard fastening screw from the motor shaft.

Fix the rear guard onto the two pillars of the motor front shell.

Screw the guard fastening screw tightly in clockwise direction.

4. The assembly of fan blade
Insert fan blade onto shaft ensuring blade fits properly onto clip on shaft.

Tighten blade screw onto shaft. Note: Blade screw should be tightened in anti-clockwise.

5. Front grille assembly
Put the front guard against the rear guard and fix with the clamping ring. Make sure the clamping ring is

set properly at the rim of the fan guards.
Tighten the screw on the clamping ring.

- 4 -
EN