Preparation (2). Initialization; Writing Model Data; Picture Output; Landing Adjustment (1) - Sony TRINITRON PVM-14L1 Service Manual

2-3. Preparation (2). Initialization

* Supply composite video signal as shown in Table 2-1.
Signal
Composite 358NT
video
PAL
Voice/sound
Table 2-1

2-4. Writing Model Data

1. Select the following sub menus from the Service Menu
in the order of : [SYSTEM] → [MODEL INCH],
[SYSTEM] → [MODEL TYPE] and write the model
data of each model in the [MODEL TYPE] referring
to table 2-2.
Model name Model type
PVM-14L1 J
PVM-14L1 WW EXCEPT J
SSM-14L1 J
SSM-14L1 WW EXCEPT J
PVM-20L1 J
PVM-20L1 WW EXCEPT J
SSM-20L1 J
SSM-20L1 WW EXCEPT J
Table. 2-2
2. Select the following sub menus from the Service Menu
in the order of : [SIGNAL] → [WHITE BALANCE]
and type the following data in [COLOR TEMP].
WW EXCEPT J D65
J D93
* Standard inspection state
Unless otherwise specified in this manual, make adjust-
ment under the following conditions.
VOLUME 0
CONTRAST 80
BRIGHTNESS 0
CHROMA 50
PHASE 0
ASPECT RATIO 4 : 3
2-6
Details of signal Standard
level
P-W
100 % white 0.714 V
75 % white 0.536 V
100 % white 0.7 V
75 % white 0.525 V
_5 dBu 0.436Vrms
Model inch
14
14
14
14
20
20
20
20

2-5. Picture Output

1. AC input voltage setting
1. Input VIDEO signals and AUDIO signals to respective
terminals on the connector panel.
2. Set the slide induction transformer AC voltage as
shown in Table 2-3.
Model name
PVM-14L1
PVM-20L1
SSM-14L1
SSM-20L1
Table. 2-3

2-6. Landing Adjustment (1)

1. CONTRAST... MAX
BRIGHT... Conspicuous position
2. Roughly adjust the white balance, G2, and conver-
gence.
3. Switch the video signal generator output signal to
green only.
4. Move back the DY backward (in the direction toward
neck).
5. Adjust the purity knob so that the green will come to
the center of the screen. Make R and B almost
identical. (Fig. 2-1)
6. Switch to B only, R only, and G only and verify each.
7. Bring the deflection yoke gradually forward and adjust
the deflection yoke so that R and B on both sides of
the screen will be green. (Fig.2-2 → Fig. 2-3)
8. If the deflection yoke comes forward too much, the
pattern shown in Fig.2-4 will appear. If so, move the
deflection yoke backward. (Fig.2-4 → Fig.2-3)
9. Switch the signal generator output signal to the BLUE
only color and confirm the screen. (Fig. 2-6)
10. Switch the signal generator output signal to the RED
only color and confirm the screen. (Fig. 2-9)
11. When two colors are mixed, set the mixed color as the
standard, and repeat operations 6 and 7.
12. Switch to an all-white signal and check the uniformity.
13. When the deflection yoke position is determined,
fasten it with the DY screw.
Voltage
AC 100 V to 240 V ±10 %
PVM-14L1/14L1MDE/20L1
SSM-14L1/20L1