DeWalt DXPW3200V Manual page 14

English
The manufacturer will honor the terms of all component
warranties and satisfy claims of the appropriate warranty
provisions through a network of factory authorised and trained
Warranty Service Centres. To make a claim under the terms of
the warranty, all parts said to be defective must be retained
and available for return upon request to a designated Warranty
Service Centre for warranty inspection. The judgments and
decisions of the manufacturer concerning the validity of
warranty claims are final.
Any product subject to a warranty claim-- please call the
phone numbers listed below for specific warranty instructions,
procedures, and information regarding the Warranty
Service Centres.
You must present proof of purchase when making a
warranty claim.
Australia Phone : 1800 841 749
New Zealand Phone : 0800 467 813
FNA Group, Inc. / Mayo Hardware PTY LTD 4 Secombe Place
Moorebank NSW 2170 Australia
Glossary
Psi: Pounds per Square Inch. The unit of measure for water
pressure. Also used for air pressure, hydraulic pressure, etc.
LPM**: Liters Per Minute. The unit of measure for the flow
rate of water.
Psi**: Pounds per Square Inch. The unit of measure for water
pressure. Also used for air pressure, hydraulic pressure, etc.
** Values are within manufacturing tolerance of +/- 10%.
Bypass Mode: Allows water to re-circulate within the
pump when the gun trigger is not pulled. This feature
allows the operator to release the trigger gun and reposition
themselves without having to turn the engine off in between
cleaning actions.

WARNING: Do not allow the unit to run for more
than two minutes without the gun trigger being
pulled. This could cause overheating and damage to
the pump. When the temperature inside the pump
rises too high, the thermal relief valve will open and
release a spray of water from the pump to lower the
internal temperature. The valve will then close.
Thermal Relief Valve: When the temperature inside the pump
rises too high, this valve will open and release a gush of water in
an effort to lower the temperature inside the pump. The valve
will then close.
Detergent injection system: Mixes cleaners or cleaning
solvents with the water to improve cleaning effectiveness.
Cold Water supply: All pressure washers must have a source
of water. The minimum requirements for a water supply are 20
psi and 38 liters per minute. If your water source is a well, the
garden hose length can only be 9 m max.
high Pressure Pump: Increases the pressure of the
water supply.
Engine: Drives the high pressure pump. Refer to the Engine
Owner's Manual for location and operation of engine controls.
12
high Pressure hose: Carries the pressurized water from the
pump to the gun and spray wand.
spray gun: Connects with spray wand to control water flow
rate, direction, and pressure.
Choke Control: Opens and closes carburetor choke valve.
starter grip: Pulling starter grip operates recoil starter to
crank engine.
Engine switch: Enables and disables ignition system.
Quick-Connect spray Wand: Allows the user to quickly
change out high pressure nozzles.