When you need to disconnect power from the equipment, be sure to unplug the power cord from the electrical outlet. Acer and the Acer logo are registered trademarks of Acer Incorporated. Other companies' product names or trademarks are used herein for identification purposes only and belong to...
Safe listening To protect your hearing, follow these instructions. Note: The grounding pin also provides good protection from unexpected noise produced • Gradually increase the volume until you can hear it clearly and comfortably and without distortion. by other nearby electrical devices that may interfere with the performance of this product. • After setting the volume level, do not increase it after your ears have adjusted.
Long work periods, bad posture, placed on the environment. We at Acer are very conscious of the environmental effects of our poor work habits, stress, inadequate working conditions, personal health and other factors greatly business and strive to identify and provide the best working procedures to reduce the environmental increase the risk of physical injury.
Page 5
UT222Q xxxxxx; (“x” = 0~9, a ~ z, A ~ Z, or blank) We, Acer Incorporated, hereby declare under our sole responsibility that the product described above is in conformity with the relevant Union harmonization legislations as below Directive and following...
Page 6
Special notes on LCD monitors Acer America Corporation Information for your safety and comfort 333 West San Carlos St., Suite 1500 San Jose, CA 95110, U. S. A. Safety instructions Tel : 254-298-4000 Cleaning your monitor Fax : 254-298-4147 Connecting/disconnecting the device www.acer.com...
Please check that the following items are present when you unpack the box, and save the packing materials in case you need to ship or transport the monitor in the future. LCD monitor Quick start guide LCD monitor UT2 Series-UT222Q USER GUIDE Power cord HDMI cable (Option)
Page 8
The monitor Power saving Open or close the rear bracket. The viewing angle of the monitor can be adjusted using the stand. The monitor will be switched to "power saving" mode by the control signal from the display controller, as indicated by the orange-colored power LED. (As shown below) Model LED light...
Standard timing table Installation To install the monitor on your host system, please follow the steps below: Mode Resolution Steps 640×480 VESA 800×600 Turn off your computer and unplug your computer's power cord. VESA 1024×768 Connect the signal cable to the HDMI (optional) and/or DP(optional)inputsocketofthemo nitor,andtheHDMI(optional) and/orDP (optional) output socket ofthe graphics card on the VESA 1280×960...
User controls Adjusting the OSD settings Power Switch / Power LED: Note: The following content is for general reference only. Actual product specifications may To turn the monitor ON or OFF. vary. Lights up to indicate the power is turned ON. The OSD can be used for adjusting the settings of your LCD Monitor.
Free Sync: To set FreeSync on/off. signal cable or switching off the monitor. Note: Acer monitor is purposed for video and visual display of information obtained from Memory Recall: Restore default settings of Clock, H./V. Position, Contrast, Brightness, ECO, electronic devices.
Need help?
Do you have a question about the UT222Q and is the answer not in the manual?
Questions and answers