How To Sing With Cd+G, Usb Or Aux-In Music Source - auna Microstar Sing Manual

EN
48
(included) to this jack and the other end to the VIDEO/AV INPUT of your
TV.
• AUDIO OUT JACKS (L/R): Connect the white coded RCA plug (L) and red
coded plug (R) of the A/V cable (included) to these jacks and the other
end to the audio inputs of your TV.
Karaoke control funktions
• MASTER VOLUME: Adjust this to obtain the desired volume level from
the built-in speaker.
• AVC (AUTOMATIC VOICE CONTROL) BUTTON : When AVC is activated,
the vocals on a multiplex recording are eliminated as soon as the singer
begins singing into the microphone. When the singer stops singing, the
vocals on the multiplex recording are automatically re-activated. This
function is used primarily during practice sessions
• MIC VOLUME: Adjust this control to obtain the desired mic volume
output during singing. Volume level of both Mic 1 and Mic 2 will be
adjusted at the same time.
• ECHO CONTROL: Press the ECHO button on the remote control for a
more significant echo effect to enrich your voice for a concert hall effect.
HOW TO SING WITH CD+G, USB OR AUX-IN
MUSIC SOURCE
Getting prepared
• Connect your unit to a compatible TV using the included A/V cable.
• Plug in the included MICROPHONE into either the MIC 1 or MIC 2 JACK
Note: Always set the mic to OFF until you are ready to sing to avoid possible
sharp feedback noises.
Singing along with CD+G, CD, CD-R/CD-RW or USB flash drive with MP3
files
1. Set the SOURCE selector to "CD".
2. Load a CD/CD+G disc as follows: Grip the top front edge on the CD
DOOR where indicated and pull gently to open it. The LED DISPLAY will
display "OP".Load a disc vertically into the compartment with the printed
side facing you. Gently close the CD DOOR. The unit begins to read the
disc. The LED DISPLAY will display the total number of tracks. (If no disc
is loaded or the disc cannot be recognized, "No" will be displayed in the
LED DISPLAY). When a CD+G disc is detected and being played, the CDG