Installing The Rear Inner Rails; Installing The Rack Rails - American Megatrends StorTrends 1100-P Setup Manual

Installing the Rear Inner Rails

First, locate the right rear inner rail (the rail that will be used below side of the chassis
when you face the front of the chassis). Align the two square holes on the rail against the
hooks below side of the chassis. Securely attach the rail to the chassis with M4 flat head
screws. Repeat these steps to install the left rear inner rail to the left side of the chassis
(see Figure 2-1).
Locking Tabs
Both chassis rails have a locking tab, which serves two functions. The first is to lock the
server into place when installed and pushed fully into the rack, which is its normal
position. Secondly, these tabs also lock the server in place when fully extended from the
rack. This prevents the server from coming completely out of the rack when you pull it
out for servicing.
Figure 2-1. Installing Rear Inner Chassis Rails

Installing the Rack Rails

Determine where you want to place the StorTrends® 1100 Storage Appliance in the rack
(see the Rack Precautions and Server Precautions). Position the chassis rail guides at the
desired location in the rack, keeping the sliding rail guide facing the inside of the rack.
Screw the assembly securely to the rack using the brackets (01-01-813811-XXA)
provided. Attach the other assembly to the other side of the rack, making sure that both
are at the exact same height and with the rail guides facing inward.
6 StorTrends® 1100 Set Up Guide