Mounting The Base; Adjusting The Wire Stand; Wire Stand Positions; Effects Of High Or Low Voltages - Aerus Air Scrubber Owner's Manual

MOUNTING THE BASE

The base for the Air Scrubber Mobile by Aerus can be mounted using the included suction cups, Velcro, or screws, depending on
preference . When using suction cups or Velcro, be sure the surface is smooth and clean . Dirt, grease, protectants, and other substances
will affect performance and holding ability .
• Attach suction cups by pressing and twisting
into the base, or . . .

ADJUSTING THE WIRE STAND

The wire stand on the Air Scrubber Mobile by Aerus allows for quick release from the base, provides a stand or hanger for the unit
independent of the base, and allows the unit to either stand or hang from the base depending on how the base is mounted .
To adjust the wire stand, loosen the two knobs on the sides of the unit approximately 1/2 turn . The unit may then be tilted up or down
to adjust the angle or moved on the wire stand to change the height . You can also remove and change the position of the wire stand to
accommodate several different mounting methods . To reinstall, simply align the two clamp collars and insert the wire stand . Once the
unit is adjusted, tighten both knobs to hold it in place .

WIRE STAND POSITIONS

EFFECTS OF HIGH OR LOW VOLTAGES ON AIR SCRUBBER MOBILE BY AERUS
WHEN USING THE 12VDC CAR ADAPTER
Air Scrubber Mobile by Aerus has an operating voltage range of 11 VDC to 14 .6 VDC . If the voltage coming into the unit is too high, the
unit may blow the 12VDC adapter fuse . This type of problem usually indicates something is wrong with a vehicle's electrical system . If
the unit shuts down while using the 12VDC automotive adapter and you are unsure of the cause, check the adapter fuse . If the fuse is
not blown, test the unit using the supplied AC adapter . Once the voltage problem (drained car battery, electrical system problem, etc .) is
corrected by a qualified service person, you will be able to resume using your Air Scrubber Mobile by Aerus with the 12VDC adapter .
4
• Peel and stick one part of the Velcro to the
base, then attach the other to a clean, dry
surface, or . . .
THEN
• Sitting on a flat surface with or without
the base
• Hanging over an edge pointing down
(laundry hamper, garbage can, etc . )
• Screws may be used for extra security
and where the other methods are not
appropriate .
OR
• Sitting on a flat surface without
the base
• On a vertical surface with the
base (wall mount, window, etc . )
• Hanging over an edge pointing
up (seat pocket in car)
NOTE: Unit can be used without
attaching the base or wire stand .