Table of Contents
Advertisement
2-17 Safety Interlock Harness
Installation
Collection System May Require Dealer Installation!
Before installing, please verify the presence of an
auxiliary 5-way female connector in the mower's
electrical harness. The connector is located underneath
the operator's seat in between the two hydraulic pump
cooling fans.
WARNING
!
To Prevent Serious Injury-
Proper Installation Of Safety Interlock Harness
Is Mandatory. Please Check That All Interlock
Points Work Correctly Once Installed.
Connect (A) the Delphi 5-way Male Connector, on the
harness, to the connection point under the seat and
between the two cooling fans. Next, on the left side of
the engine locate and separate the engine harness from
the mower's main harness. Connect (B) to the engine
side connector and (C) to the main harness connector.
Refer to Figure 2-17a & 2-17b.
Figure 2-17a
(A)
Connection
Point
(D) Drive Clutch Connector
(E) PTO Switch
(B & C)
Interconnect
Route the Drive Clutch Connector (D) around the front
side of the engine, between the ROPS and gas tank and
through the opening in the rear bumper connecting to
the quick connect plug located on the PTO Drive.
Before routing the PTO Switch (E), locate and remove
knock out on the mower's control panel. The control
panel is easily accessed by removing the (9) hex head
screws around the outside of the control panel housing.
Route (E) through the frame and up to the underside of
the control panel. Insert switch into the hole, previously
knocked out, and snap the provided retaining plate to the
underside of the control panel. The retainer plate (F)
should be seated fully over the snap wings of switch
from the underside of the panel after the switch is
installed. Connect the switch to connector and reattach
control panel.
Use the zip ties that are provided to secure in place.
D
15
Advertisement
Table of Contents
