Lower Mount Tube Installation; Upper Frame Assembly Installation; Top Assembly To Upper Frame Assembly Installation; Inlet Installation - Cub Cadet 59A30047150 Operator's Manual

Power assist triple bag for ro z 500, 700, 900 l&s
Table of Contents

Advertisement

2-5 Lower Mount Tube Installation

Secure the (2) Lower Mount Tubes P#(B0752) to the
rear frame using (2) 5/16"-18 U-bolts P#(K1098) and (4)
5/16"-18 Ny-Flange Lock Nuts P#(K2516) PER TUBE.
Refer to Figure 2-5. Note: Bottom of Tubes should rest
on the top edge of the Trailer Hitch Plate.
Figure 2-5
2-6 Upper Frame Assembly
Installation
Lift the Upper Frame Assembly P#(A2068) into position,
and slide onto the Lower Mount Tubes as shown in
Figure 2-7 and secure with (2) 1/2" x 2-1/4" Clevis Pins
P#(K0133) and (2) Hair Pin Clips P#(K0088). Note: It is
recommended that someone assist you when installing
the upper frame assembly.
2-7 Top Assembly To Upper Frame
Assembly Installation
Position the Top Assembly P#(A2081) above the Upper
Frame Assembly with the Rubber Dust Guard positioned
towards the seat as shown in Figure 2-7. Fasten the Top
Assembly to the Upper Frame Assembly using (2) 5/16"-
18 x 2-1/2" HHCS P#(K0125) and (2) 5/16"-18 Ny-
Flange Lock Nuts P#(K2516). Leave the lock nuts
slightly loose, to allow the top assembly to open and
close easily. Refer to Figure 2-7 for hardware location.
10
10
Trailer Hitch Plate
Figure 2-7
Hair Pin
Clip
Top Assembly
(2) 5/16"-18 x 2-1/2" HHCS
Inlet

2-8 Inlet Installation

Insert the Inlet P#(A2074) into the hole on the Top
Assembly from the inside and then snap the Inlet into
place. The Inlet should pivot freely about the hole.
2-9 Hinge Kit Assembly Installation
Assemble the Hinge Kit as shown in Figure 2-9, using
(1) Latch Plate P#(B0884), (1) 5/16"-18 x 1-1/4" HHCS
P#(K1156), (1) 5/16"-18 Ny-Flange Lock Nut P#(K2516),
(3) 5/16" Flat Washers P#(K0042), (1) Latch Spacer
P#(S0006), (2) Extra Heavy 5/16" Fender Washers
P#(K0505) and (1) 5/16"-18 Lock Nut P#(K0506). Leave
the nuts loose enough to allow fluid movement of the top
when opening and closing. When opened, the top should
rest in the Latch Plate Slot.
Figure 2-9
K0042
S0006
K1156
K0506
Clevis
Pin
Nylon
Flange
Locknut
Hex
Bolt
Rubber
Dust Guard
(2) 5/16"-18 Locknuts
K2516
K0042
K0505
B0884

Advertisement

Table of Contents
loading

This manual is also suitable for:

21131509

Table of Contents