Advertisement
Clear an Alarm
To clear the alarm whose information appears on the
LCD press Clear.
Control Dome Outputs
1. Refer to the Dome Input / Output chart to see which
outputs are connected to which domes, and what the
on / off states are for those domes.
2. Press the number of the camera whose output you
want to turn on or off, then press Camera.
3. Press the number of the output (1 - 4) that you want
to turn on or off.
4. Press Output On to turn the Output on; press
Output Off to turn the Output off.
Display a Quick View
Note: SpeedDome Ultra III supports 96 views. Other
domes support 4 views.
1. Press the number of the camera whose Quick View
you want to display, then press Camera.
2. Press the number of the Quick View you want to
display (1 - 96), and then press View.
Run a Pattern
1. Press the number of the camera whose Pattern you
want to display, then press Camera.
2. Press the number of the Pattern you want to display
(1 - 3), then press Pattern (if you want the pattern to
run one time only) or Repeat Pattern (if you want the
Pattern to repeat itself indefinitely).
If you select a repeating Pattern, the Pattern will repeat
itself until you issue a camera command (pan, tilt zoom
or focus) to the dome running the Pattern.
Run the Sequence
To initiate the pre-defined Sequence, press Seq. The
Sequence will repeat itself indefinitely until you press
Seq or Clear.
RCTT16BE / VM16 PLUS ENHANCED TOUCH TRACKER
8000-2654-01, REV. A1
Define a Quick View
Note: SpeedDome Ultra III and newer domes supports
96 views. Other domes support 4 views.
1. On the monitor, display the picture for which you
want to create a quick view.
2. Press Menu to display the LCD Menu. Use the
Tracker Ball to scroll through the choices.
3. Press Zoom or Focus to select Setup View.
4. Press the number buttons (1 - 96) that you want to
assign to this Quick View.
5. Press Zoom or Focus to save.
Define a Pattern
1. On the monitor, display the picture that you want to
be the starting point of the Pattern.
2. Press Menu to display the LCD Menu. Use the
Tracker Ball to scroll through the choices.
3. Press Zoom or Focus to select Record Pattern.
4. Press the number (1 - 3) that you want to assign to
this pattern.
5. Move the camera around, zoom and focus as
necessary to create a logical camera pattern.
If you make a mistake during programming and no
longer want to program the pattern, press Clear.
6. When you complete creating the pattern, press Next.
SpeedDome LT Auto Pan
Programming
1. On the monitor, display the picture that you want to
be the starting point of the Auto Pan.
2. Press Menu to display the LCD Menu. Use the
Tracker Ball to scroll through the choices.
3. Press Zoom or Focus to select Record Pattern.
4. Press the number 1 on the keypad.
5. Move the camera to the end point, then press Next.
When you select Pattern 1 for this dome, the camera will
pan smoothly from side-to-side until another camera
command is issued.
QUICK REFERENCE GUIDE
3
Advertisement
