Related Manuals for SY HDBT-662
Summary of Contents for SY HDBT-662
- Page 1 User Manual HDBT-662 6 Input Dual Zone HDBaseT Distribution Amplifier SY Electronics Ltd., 7 Worrall Street, Salford, Greater Manchester, M5 4TH Tel: +44 (0)161 868 3450 – Fax: +44 (0)161 868 3459 Web: sy.uk...
- Page 2 The SY-HDBT-662 is a six input distribution amplifier with dual output zones. Available inputs are four HDMI inputs, one DisplayPort input and one VGA input. Each of the two output zones provides a local HDMI output and three HDBaseT outputs, the input source for these zones are independently selectable from either the front panel buttons, using RS232 commands or the Ethernet port.
-
Page 3: Front Panel Led Indications
Up to four HDMI sources, one DisplayPort source and one VGA source may be connected to the SY-HDBT-662. Each of these inputs can be independently selected to the two output zones. The output connectors in a single Zone will all show the same input signal, but each output Zone can show different inputs. -
Page 4: System Settings
1 for zone outputs, or 2 for Zone 2 outputs Where y is: 1 – 4 (HDMI 1 – 4), 5, (DisplayPort), or 6 (VGA) GET OUTx VS Get the currently selected input for output zone x (1 or 2) sy.uk V1.0... -
Page 5: Audio Settings
GET IN6 EDID y DATA and y is the VGA index value given below in the Default EDID Settings table Get the EDID data for the display device connected to the SY- GET OUTx EDID DATA HDBT-70SR receiver Back Panel PB Input Selection... - Page 6 Where x is: 1 – 3 for Zone 1 HDBaseT outputs 1 to 3, or 4 – 6 for Zone 2 HDBaseT outputs 1 to 3 Get the current HDBaseT output that is set for RS232 pass- GET BPSEL HDBT through sy.uk V1.0...
-
Page 7: Using The Web Interface
Use Disable to set Zone 1 IR IN to output only to Zone 1 Using the Web Interface The SY-HDBT-662 also has a built-in web interface that can also be used to control the unit for input selections, EDID settings and network management. The default IP settings... -
Page 8: Specifications
RJ45 Wiring Both connectors must be wired identically. HDBT will not pass through any Ethernet device, the HDBT port on the SY-MFT21 must be connected directly to the HDBT port on the SY-HDBT-70SR. Please do make sure that the Cat6 cable uses 4 pairs of 23AWG solid copper wires. Do not use inferior copper clad cables as these exhibit high resistances. - Page 9 Online registration of these products is required to activate the full three year extended warranty. For full details please refer to our Terms and Conditions. 4. SY Product warranty is automatically void under any of the following conditions: The product is already outside of its warranty period ...
- Page 10 NOTES sy.uk V1.0...
- Page 11 NOTES V1.0 sy.uk...
- Page 12 NOTES sy.uk V1.0...
Need help?
Do you have a question about the HDBT-662 and is the answer not in the manual?
Questions and answers