Digialert Event Management; Installing Digialert On Your Pc; Digialert Setup On Digimux - American Dynamics DigiMux DG4004 Quick Setup Manual

Quick Setup Guide

DIGIALERT EVENT MANAGEMENT

NOTE: You must have a modem connection and the IP address of your PC to
install and operate DigiAlert. See
page 6 or
User's Manual for more information.

Installing DigiAlert on your PC

1. On your PC, start your web browser and enter the DigiMux unit's IP Address in the
Address field.
NOTE: Do not enter leading 0 characters. For example, 050.244.060.002
2. If you are downloading DigiClient, then click the Download DigiAlert box and
click Accept to accept the License Agreement.
3. When the File Download box is displayed, click Open to download DigiAlert. The
DigiAlert installer is then displayed.
4. Click Next for each screen and then click Install. DigiAlert is installed during the
next few minutes.
5. When the installation is successful, the Installer displays a final screen.Click
Finish to complete the installation.

DigiAlert Setup on DigiMux

1. Setup on the DigiMux depends on whether you have a LAN Internet connection, or
a Dial In/Out Modem connection. Follow the Setup information in
the DigiMux
information on how to set up a connection.
2. See your System Administrator or use the ipconfig /all command on the DOS
command line to determine your PC's IP Address.
NOTE: If you are using a DHCP connection and you shut off the PC, your IP
address may change. It is best to set up DigiAlert on a PC with a
static IP Address. If you are using DHCP, regularly check your IP
Address.
16
Dial-In/Out Modem Setup
is entered 50.244.60.2.
or Dial-In/Out Modem Setup
on page 6
LAN Setup for the DigiMux
on page 7 and the DigiClient
on page 7
on
LAN Setup for
for
Quick Setup Guide