Advertisement
Available languages
Available languages
–
Locations where other objects will obstruct the area around the Trunk Adaptor.
Be especially careful to leave at least 5 cm to the sides of the Trunk Adaptor
for ventilation.
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Do not bundle cables that are connected to the Trunk Adaptor with the AC power
cords of machines located nearby.
•
To prevent malfunction, deformity, overheating, rust, and discolouration, do not
install or place equipment in the following types of locations:
–
Locations where air ventilation is poor.
–
Locations that may be exposed to sulphurous gas, such as near hot springs.
–
Near devices that emit heat, such as heaters.
–
Near devices that emit electromagnetic noise, such as radios or televisions.
–
Near devices that emit high-frequency noise, such as sewing machines or
welders.
•
The Trunk Adaptor and the cables should never be placed near or over a radiator
or other heat source.
•
The Trunk Adaptor should not be placed outdoors (use indoors).
•
The Trunk Adaptor should not be placed near high-voltage equipment.
•
The Trunk Adaptor should be kept free of dust, moisture, high temperature (more
than 40 °C), low temperature (less than 0 °C), and vibration, and should not be
exposed to direct sunlight.
•
Before touching the product, discharge static electricity by touching ground or
wearing an earthing strap. Failure to do so may cause the Trunk Adaptor to
malfunction due to static electricity.
•
When relocating the equipment, first disconnect the telecom connection before
disconnecting the power connection. When the unit is installed in the new location,
reconnect the power first, and then reconnect the telecom connection.
•
Make sure that the surface behind the Trunk Adaptor is not made of wood.
•
When driving the screws into the wall, be careful to avoid touching any metal laths,
wire laths or metal plates in the wall.
•
When mounting the Trunk Adaptor on a wall, be sure to run the cables down the
side of the Trunk Adaptor. Do not run the cables down the front of it.
•
When the Trunk Adaptor is placed on a desktop, make sure that it is placed flat. Do
not place it on its side or upside down.
•
When placing the Trunk Adaptor on a desktop, be sure to run the cables on the side
of the Trunk Adaptor. Do not run the cables on top or under it.
•
It is strongly recommended to use SSL encrypted communication when the PC is
accessing the Trunk Adaptor via the Internet. To use SSL encryption, routers must
have a port set up for https communication.
•
Avoid using the same AC outlet for computers and other office equipment, as noise
generated by such equipment may hamper system performance or interrupt the
system.
4
Advertisement
