Grundig 32 GLX 3023 Manual page 25

INFORMATION
Additional­Information­for­units­
sold­in­the­UK.
Units sold in the UK are suitable for operation
from a 240V ac, 50Hz mains supply.
The range of multi-system receivers is built to
work in most European countries. However, the
mains plug and socket system for the UK differs
from many European countries.
This appliance has been supplied with a fitted,
non-removable, approved converter plug for
use in the UK. This converter plug is fitted with a
5A rated fuse.
In case this appliance is supplied with a
moulded 2-pin Euro plug only, which is unsuit-
able for UK operation, this must be cut off and
immediately disposed of. An approved 13A,
3-pin UK plug should then be fitted by a quali-
fied electrician.
Note:
The severed Euro plug must be destroyed to
7
avoid a possible shock hazard should it be
inserted into a socket elsewhere.
If a non-rewireable 3-pin plug or a rewireable
13A (BS1363) 3-pin plug is used, it must be fit-
ted with a 5A ASTA or BSI approved BS1362
fuse. If any other type of plug is used it must be
protected by a 5A fuse either in the plug, or at
the distribution board. If this type of plug be-
comes defective, ensure that the fuse is removed
before disposal, to eliminate potential shock
hazard.
If it is necessary to change the fuse in the non-
rewireable plug, the correct type and rating
(5A ASTA or BSI approved BS1362) must be
used and the fuse cover must be refitted. If the
fuse cover is lost or damaged, the lead and
plug must not be used until a replacement is
obtained. Replacement fuse covers should be
obtained from your dealer.
Important:
The wires in the mains lead are colour coded
7
in accordance with the following code:
BLUE – NEUTRAL
BROWN – LIVE
26­
ENGLISH
­ - -----------------------------------------------------------------------------------------------------------------
As the colours of the wires in the mains lead of
your appliance may not correspond with the
coloured marking identifying terminals in your
plug, proceed as follows:
Connect the BLUE coloured wire to plug ter-
minal marked with the letter "N" or coloured
black.
Connect the BROWN coloured wire to the plug
terminal marked with the letter "L" or coloured
red.
In no circumstance must any of the wires be
connected to the terminal marked with the letter
"E", earth symbol "V", coloured green, or green
& yellow.