Magneto Stator (Extraction And Installation) - um CBF 125 Service Manual

7.4. Magneto stator (extraction and installation)

7.4.1. Remove rubber plug, magneto cable clip
and sensor
7.4.2. Dismantle fastening bolts on stator and
take out magneto
7.4.3. Install a magneto onto left cover, then
tighten bolts
7.4.4. Install sensor and tighten bolts
Press cable
corresponding position on left cover, and
tighten bolts
Note:
When assemble magneto cable clip, collect the
harness into groove to avoid harness damages;
otherwise, a short circuit may be generated.
Tightening torque of bolt: 12N.m
7.4.5. Install left cover onto engine (refer to 7.2
section).
CBF 125 AIR COOLING ENGINE SERVICE MANUAL
RENEGADE SPORT & SCRAMBLER X 125 EFI
clip of magneto into
81