Razor Kobalt Owner's Manual page 11

REPAIR AND MAINTENANCE
Rear Wheel/Hub Motor Replacement
Required Tools: Phillips Screwdriver and Two (2) 13 mm Wrenches (not included)
1
Release the two (2) side buttons and push out the
battery from the battery dock.
C
C
C
C
3
Using a Phillips screwdriver remove six (6) screws
and remove the deck plate.
5
Remove motor cable wires from connector using
an awl.
7
Using a 13 mm wrench, loosen the outside locknut
while using another 13 mm wrench to prevent the inside
nut from turning. Remove wheel/hub motor.
Kobalt_LowesSMU_US_MAN_200812.indd 10 Kobalt_LowesSMU_US_MAN_200812.indd 10
A x 6 B x 1
2
Using a Phillips screwdriver remove seven (7) screws
and remove the battery dock cover.
Note: There are two (2) sizes of screws,
A-Flat, B-Pointed
C x 6
C
C
4
Disconnect motor cables.
Red
Black
6
Remove two (2) motor housing screws using a
Phillips screwdriver.
8
To install the replacement wheel/hub motor, reverse
steps 1-7.
A
A
A
A
A
A
10 10
B
Note: When re-inserting the motor
wires into the connector, make sure
the red wire connects to the blue
wire and the black wire connects to
the brown wire.
Note:
Motor Control Module
Red 1 Blue
Black 1 Brown
Note: Rear wheel
hardware sequence.
Left Side
12-1 Phillips Screws
12-2 Motor Housing
Right Side
12-3 Spacer
12-4 Nut
Frame
12-5 Flat Washer
12-6 Lock Washer
12-7 Locknut
12-3
12-4
12-5
12-6
12-1
12-2
12-7
8/12/20 1:10 PM 8/12/20 1:10 PM