Table of Contents
Advertisement
6. EXTERNAL POWER SUPPLY
Connect a power supply with a voltage
of 9 – 15 V.
In order that the LITTLE LEHLE III can
work flawlessly, it needs a current sup-
ply. This should supply a minimum of 9
V and a maximum of 15 V. Polarity is of
no importance. The supply voltage is in-
ternally rectified and stabilized in order to
guarantee trouble-free operation. In or-
der to avoid noise it's recommendable to
use a single power supply or an output of
a multi power supply offering galvanically
isolated outputs for the LITTLE LEHLE III.
7. LED FOR SWITCHING STATUS
If the LED shows white, the input (1) is di-
rectly connected to the output (5).
The high-intensity LED clearly indicates
the current switching status - even under
bright spotlights.
When you use the LITTLE LEHLE III as an
effects loop switcher and the LED shows
white, the effects are in Bypass, when
blue they are in the signal path.
If you use it as A/B switch between two
amplifiers it means the LED is white for
the amplifier at the output (5) and blue for
the amplifier at the send (3).
Same applies for switching between two
instruments: LED white means that the in-
strument at the input (1) is active, blue ap-
plies for the instrument at the return (4).
LEHLE GmbH · Germany · www.lehle.com · support@lehle.com
8. BASE AND FIXING
If required, mount the LITTLE LEHLE III to
a pedalboard using the mounting kit.
The LITTLE LEHLE III can be mounted to a
plate such as a pedalboard using the two
holes in the bottom of the pedal.
You can find the optional LEHLE Mount-
ing Kit V3 (order number 100981) online
at www.lehle-components.com.
To mount, undo the four housing screws
by using a 2.5 mm Allen Key and detach
the cover.
Then fix the device base to a base plate
using the two screws, the washers and the
spacers of the Mounting Kit.
Attach the cover and tighten the four
housing screws - done!
For flexible solutions we recommend us-
ing 3M Dual Lock™ instead of Velcro for
stability, which you can also find in handy
sizes at www.lehle-components.com
Tip: if you are using the Velcro / Dual
Lock™ method, please make a note of
the serial number on the bottom of the
pedal before you cover it, in case you
have a support question for us later and
don't fancy dismantling your board!
9
!
Advertisement
Table of Contents
